

I own the 2008 Busa and the dyno operator/owner of Dyno Masters in Chattanooga Tn. Mark Hromi owned the ZX-14. Our intentions were to test both bikes stock and run them 3-5 pulls each and then pull them off the dyno and install a Power Commander and map each one at 100% on the DJ250I machine using the Tuning link software and then run them both again for HP/Torque.

The Busa power commander (2007 GSXR1000 PC actually) plugged in just fine and all was well but for some reason the 2006 ZX-14 Power Commander caused the ZX-14 not to run at all. So we were unable to map the ZX-14 . And as you see the air fuel curve on it is really rich and no doubt a lot of power is being lost. You can see exactly at the point the air fuel goes rich the power starts to lose its upward slope and it noses over.

I know all the Kawi guys are going to cry foul but personally I dont know what else we could have done to make this fair. Same day, same dyno, back to back runs on a great day with pump gas etc. The dyno is a VERY well maintained machine and the numbers on the busa seem to be very close to the others I have seen reported from Dynojet etc when everybody uses SAE reporting not STD. Also both bikes were bought locally off the dealer floor. These were not sent to me from Kawasaki or Suzuki, these are RETAIL bikes.
credit : www.hayabusa.org
No comments:
Post a Comment